|
The AQUACLIP® Sealing System
Sealed with a Twist: The Aquaclip is the key to all Aquapacs. An amazing little device which seals the case with a simple twist of a lever. It has a V-groove in one half and a raised V on the other. When the levers on the male half are turned they run up a ramp on the female half – squeezing the two together. The pressure’s not sufficient to cut the soft plastic case material, but just enough to make a totally hermetic seal. The two halves are attached to the case by a pair of ‘flexible clips’ in such a way that the whole case stays in one piece, even when open.
Award Winning: The Aquaclip was awarded Millennium Product Status by the British Design Council. A government initiative to recognize "one of the most innovative products created in Britain for the new Millennium". Aquapac has also been awarded with the Queen's Award for Enterprise: Innovation 2007 as recognition for achievement in continuous innovation and development.
Tested to Destruction: The Aquaclip is made entirely of light injection-moulded plastic. So it can’t rust. The Aquaclip has passed the two most demanding of all waterproofing standards – IP67 and IP68. Find out more. In tests at Bath University the lever mechanism was tested for 10,000 cycles of opening and closing, with no loss of function.
User Friendly: When you open an Aquapac everything stays in one piece. No loose screws. No need to fold the end of the case. Simple.
Fully Patented: The Aquaclip is fully-patented in the USA and most of Europe, and the subject of pending protection all over the world.
Beware of Cheap Imitations! There are cheap Asian-made cases circulating in some countries – many of them illegal because they infringe our Patent rights. Think carefully before buying. If it doesn’t say Aquapac on the clamp, it’s not a genuine Aquapac.
« Back
|
